Blistery cold weather is starting to sink in, which ought to ignite an instinctual desire to get your house in order and monitor it so the water pipes don’t freeze and burst. So, we’ll take a timely look at a project setting up some temperature probes in various areas, reading them, and reporting in a custom dashboard. A true home automation expert would take things further by setting up relays to turn on heat tape or even maybe some actuators to control water flow. Maybe next year, but for now, we just want to be able to monitor important areas of our home (in this case a cabin in Montana) and understand temperature patterns over time for better planning. As with most projects, there is more than one solution, especially if it depends on what you have on hand. At the time, the list of things in hand were as follows:
This practical guide gives us an opportunity to take a relaxed approach to getting started with the TS-7600 single board computer paired with the TS-ENC750 enclosure with TS-752 baseboard. We’re going to take a look at how to make our first connections, talk about the Linux environment, and setup the network. These are usually the first things we do before starting development. In the grand scheme of things, this is just a friendlier extrapolation from the official TS-7600 manual, so be sure to keep it handy for more advanced topics and specific details. The only assumption being made is that you’ve purchased the TS-7600 with a development kit, including the pre-programmed microSD card and TS-ENC750 and TS-752 baseboard. Right then, let’s get started!